Peerless PTS510I-W Specifications download pdf (Page 6)

•

attached, but do not overtighten. Overtightening

can damage screws, greatly reducing their holding

power.

• Never tighten in excess of 80 in • lb (9 N.M.).

WARNING

• Always attach concrete expansion anchors directly

to load-bearing concrete.

• Never attach concrete expansion anchors to

concrete covered with tile, carpeting, hardwood

thicker than 5/8", custom fasteners must be

supplied by installer (not UL evaluated).

WARNING

6 of 6

ISSUED: 01-29-13 SHEET #:125-9353-1 02-23-13

WARNING

• Do not drill into mortar joints! Be sure to mount in a solid part of the cement or tile ooring. Material must meet

ASTM C-90 specications. It is suggested that a standard electric drill on slow setting is used to drill the hole

instead of a hammer drill.

• Concrete must be 2000 psi density minimum. Lighter density concrete may not hold concrete anchor.

concrete

surface

432

Position mount assembly in desired

location. Use base plate (D) as a

template to mark holes. Drill one hole

using 5/16’’ (8 mm) drill bit to a minimum

depth of 2.5" (64mm). Concrete must be

at least 2000 psi density. Insert anchor

(I) in hole ush with the oor as shown

in gure 1a. Place mount assembly over

anchor and secure with one #14 wood

screw (H) as shown in gure 2a. Tighten

fastener. Place one plastic hex screw

cover (J) over #14 screw (H).

2.5”

1 2 3 4 5 6

No comments

Peerless PTS510I-W Specifications Page 6